(An unofficial site)
1993 Lincoln Mark VIII
Radio and Speaker removal


DASH.

PRELIMINARY: DISCONNECT THE NEGATIVE BATTERY CABLE.

ANTENNA: THE FACTORY POWER ANTENNA IS LOCATED ON THE RIGHT REAR FENDER.

RADIO REMOVAL AND IN-DASH INSTALLATION:
NOTE: THE FACTORY PROVISION IS FOR A FRONT LOAD DIN STYLE RADIO. AN INSTALLATION KIT IS NECESSARY WHEN INSTALLING A SHAFT TYPE RADIO. WE RECOMMEND THE USE OF A SCOSCHE DIN1190 KIT.
HINT: THE FACTORY AMPLIFIER IS LOCATED IN THE TRUNK MOUNTED TO THE UNDERSIDE OF THE REAR DECK ALONG WITH THE SUSWOOFER.


  1. USING FORD DIN REMOVAL TOOLS INSERT THEM INTO THE HOLES ON THE OUTSIDE EDGES OF THE RADIO, FIRMLY PULL THE RADIO FROM THE DASH, UNPLUG ALL CONNECTORS AND REMOVE.


FRONT DOOR SPEAKER INSTALLATION:

NOTE. THE FACTORY PROVISION IS FOR A 6 x S" SPEAKER MOUNTED TO THE DOOR AND A 2" TWEETER/MIDRANGE IN AN ENCLOSURE MOUNTED TO THE DOOR PANEL
  1. USING A PANEL REMOVAL TOOL CAREFULLY PRY OUTWARD AROUND THE PARAMETER OF THE DOOR RELEASE HOUSING TRIM TO RELEASE AND REMOVE.
  2. CAREFULLY PRY UPWARD ON THE WINDOW SWITCH PANEL USING A PANEL REMOVAL TOOL TO RELEASE FROM DOOR PANEL, EXTRACT (2) SCREWS SECURING THE PLUG TO THE SWITCHES AND REMOVE THE PANEL.
  3. EXTRACT THE BOLT LOCATED IN THE WINDOW SWITCH CAVITY SECURING THE DOOR PANEL TO THE DOOR.
  4. CAREFULLY PRY OUTWARD ON THE DOOR LOCK SWITCH PANEL USING A PANEL REMOVAL TOOL TO RELEASE FROM THE DOOR PANEL, EXTRACT (2) SCREWS SECURING THE PLUG TO THE SWITCH AND REMOVE THE PANEL.
  5. REMOVE THE DOOR LIGHT LENS LOCATED AT THE BOTTOM OUTSIDE CORNER OF THE DOOR BY INSERTING A SMALL SCREWDRIVER INTO THE NOTCH LOCATED ON THE BOTTOM OF THE LENS AND PRY OUTWARD.
  6. EXTRACT THE SCREW SECURING THE DOOR PANEL LOCATED IN THE DOOR LIGHT CAVITY.
  7. PRY OUTWARD FROM THE TOP OF THE TRIM PANEL LOCATED AT THE TOP INSIDE CORNER OF THE OCOR PANEL BACKING THE SIDE MIRROR TO RELEASE AND REMOVE.
  8. LIFT UP ON THE PANEL TO RELEASE THE FASTENING HOOKS, UNPLUG ALL CONNECTORS AND REMOVE.
  9. EXTRACT (4) SCREWS SECURING THE SPEAKER TO THE DOOR, PULL FROM THE CAVITY. UNPLUG THE LEADS AND REMOVE.
  10. EXTRACT (3) SCREWS SECURING THE MIDRANGE/TWEETER ENCLOSURE TO THE DOOR PANEL AND REMOVE.

FRONT DOOR SPEAKER PROVISION.

REAR SEAT SIDE PANEL:

NOTE: THE FACTORY PROVISION IS FOR A 6 x 8" SPEAKER MOUNTED TO THE SIDE PANEL AND A MIDRANGE/TWEETER MOUNTED IN AN ENCLOSURE.
  1. USING A PANEL REMOVAL TOOL CAREFULLY PRY OUTWARD ON THE BOTT0M OF THE SPEAKER GRILLE TO RELEASE THE FASTENERS, PULL DOWN ON THE GRILLE AND REMOVE.
  2. EXTRACT (4) SCREWS SECURING THE SPEAKER TO THE SIDE PANEL. PULL FROM THE CAVITY, UNPLUG THE LEADS AND REMOVE.
  3. EXTRACT (2) SCREWS SECURING THE ENCLOSURE TO THE SIDE PANEL. PULL FROM THE CAVITY, UNPLUG THE LEADS AND REMOVE.



FRONT DOOR TWEETER & ENCLOSURE.


REAR SEAT SIDE PANEL SPEAKER PROVISIONS.


Send me mail
Back one page.
Back to my homepage.